Modified Mustangs & Fords Homepage
Facebook

460 Big Block Build Guideplates

Prev  Next
 
460 Big Block Build Guideplates
460 Big Block Build Guideplates
[6] When installing roller rockers on the factory heads, it was necessary to install guideplates to locate the pushrods. The factory 3⁄8-inch studs (on the rocker side) were more than adequate for most cam and valvespring combos, but these are easily swapped over to the larger 7⁄16-inch studs if need be. View Related Article
460 Big Block Build Engine Build 460 Big Block Build 460 Lincoln 460 Big Block Build Dish Pistons 460 Big Block Build Small Chamber Cylinder Heads 460 Big Block Build Cobra Jet Sized Ports 460 Big Block Build Rail Rockers 460 Big Block Build Guideplates
460 Big Block Build Four Barrel Intake Manifold 460 Big Block Build Carburetor 460 Big Block Build Dyno Test 460 Big Block Build Hooker Super Comp Headers 460 Big Block Build Dyno Test 460 Big Block Build Intake Swap 460 Big Block Build Weiand Stealth Intake
460 Big Block Build Roller Rocker Arms 460 Big Block Build Comp Cam Flat Tappet Cam 460 Big Block Build Cam Install 460 Big Block Build Timing Chain 460 Big Block Build Comp Flat Tappet Cam 460 Big Block Build Valvespring 460 Big Block Build Dyno Test
460 Big Block Build Ported Stock Heads 460 Big Block Build Exhaust Port 460 Big Block Build Valves 460 Big Block Build Head Swap 460 Big Block Build Dyno Test 460 Big Block Build Dynograph
Get Adobe Flash player
Modified Mustangs & Fords