|
19 To make the LED taillights go blink, blink, blink--like a good sequential should--we have to install the included flasher module. The new flasher is connected to the old flasher wiring. To do this, click the turn signal lever and locate the flasher under the dash near the kick panel on the driver side. Kill the ignition and remove the old flasher module. There should be a yellow/orange wire and a blue or green wire in the stock harness. Connect the new flasher module's red wire to the yellow/orange lead, and the green wire to the blue/green factory wire. Then run the black ground wire to the chassis. View Related Article
|
|