Modified Mustangs & Fords Homepage
Facebook

9 Inch Rearend Assembly Shim

Prev  Next
 
9 Inch Rearend Assembly Shim
9 Inch Rearend Assembly Shim
The pre-finished pinion support can now be married to the differential case. The Strange tech began by slipping a 0.017-inch-thick shim (as a starting point for setup) into place and then securing the pinion support with the five pinion support bolts. The pinion support is not symmetrical and will only bolt in one way. The bolts are tightened to 45 ft-lb. View Related Article
9 Inch Rearend Assembly Ring And Pinion Gears 9 Inch Rearend Assembly Ring Gear 9 Inch Rearend Assembly Ring Gears 9 Inch Rearend Assembly Carrier Bearings 9 Inch Rearend Assembly Pinion Gears 9 Inch Rearend Assembly Rear Pinion Bearings 9 Inch Rearend Assembly 9 Inch Rearend
9 Inch Rearend Assembly Pinion Preload Measurement 9 Inch Rearend Assembly Disassemble Pinion Support 9 Inch Rearend Assembly Bearing Caps 9 Inch Rearend Assembly Tail Bearings 9 Inch Rearend Assembly Shim 9 Inch Rearend Assembly Driver Side Adjuster 9 Inch Rearend Assembly Dial Indicator
9 Inch Rearend Assembly Weld 9 Inch Rearend Assembly Slot Housing Configuration 9 Inch Rearend Assembly Weld Axle Tubes 9 Inch Rearend Assembly Brackets 9 Inch Rearend Assembly Housing Ends 9 Inch Rearend Assembly Spline Axles 9 Inch Rearend Assembly Axle Studs
9 Inch Rearend Assembly Axle Seal 9 Inch Rearend Assembly Housing Washing Machine 9 Inch Rearend Assembly 9 Inch Rearend 9 Inch Rearend Assembly Finished Look
Get Adobe Flash player
Modified Mustangs & Fords