Mustang 360
The Ultimate Source for Mustang News and Reviews
Mufp 0603 08z Ford Stroker Engine Building
Back to Article View Gallery
Back to Article
8 of 31
It may seem excessive, but Marvin inspects and cleans up the lifters with a fine stone to remove any nicks and edges that could cause stress risers, friction, and potential failure. While there, check the C-clip for proper retention and the roller for proper installation and smooth operation. Check all surfaces for any irregularities. Bore-to-lifter clearance should be .001-.0025 inch. Treat the lifter bore with the same respect and attention you would each of the cylinders. This is very important for oil control and smooth operation.
More Photo Galleries
-
![]()
How It’s Made: ProCharger Supercharger
-
![]()
ProCharger Livens Up An S550 with Their All-New P-1X Supercharger
-
![]()
Add 45% Power With a Bolt-On Supercharger
-
![]()
The Test: Camshafts & Coyote Manifolds
-
![]()
Adding Silly Torque in the Staging Lanes with Ford Performance Parts’ RS Air Box and Calibration
-
![]()
Week To Wicked 1966 Mustang: Day 3
