Mustang 360
The Ultimate Source for Mustang News and Reviews
Mufp 0410 Fords Efi 20 Z
Back to Article View Gallery
Back to Article
20 of 27
One last engine problem had to be resolved. Oxygen sensors had to be put in the exhaust pipes. The decision was to use the later model 5.0 manifolds (the lower one in the photo) with the O2 sensor holes already machined-in since the exhaust system needed replacing anyway. The problem was the clutch linkage was right in the way of the downward turn of the manifold. An old trick came into play by cutting a section from the cross-shaft and moving it out with some flat stock. With proper bracing, it allowed the cross-shaft to pivot around the manifold flange.
More Photo Galleries
-
![]()
How to Calculate Compression Ratio
-
![]()
Street Manners, Viscous Throttle: Vortech’s TwinCharged EcoBoost Mustang
-
![]()
Finally! A Performance Cylinder Head for Ford Six-Cylinders
-
![]()
Week to Wicked 2013 Ford Mustang Build Presented by Continental Tire
-
![]()
Recondition a Mustang’s ignition system with MSD
-
![]()
We remedy oil pump reliability in our Continental Tire Week to Wicked 2013 Mustang GT
Mustang 360
Subscribe to a Magazine
© 2018 Mustang 360 Network
Extreme Ventures, LLC dba TEN: A Discovery Communications Company.
All rights reserved.