Mustang 360
The Ultimate Source for Mustang News and Reviews
M5lp 1111 Boss 302 Bolt Ons Boss Flog 006
Back to Article View Gallery
Back to Article
11 of 20
Zex kits offer a compact, clean installation. Part of this is because the solenoids and electronics are all housed in a single nitrous management unit. To avoid making too many permanent mods to the Boss, Jesse mounted the NMU to the back of the JLT airbox. The NMU requires only nitrous and fuel connections and three wires to get it up and running. Aside from power and ground, one wire taps into the factory electronic throttle wiring. With this signal, it uses the wide-open-throttle voltage to engage the fun.
More Photo Galleries
-
![]()
Heat Blocking, Noise Cancelling Technology
-
![]()
Vintage Mustang Tech Advice for an Overheated 1965 Mustang Convertible
-
![]()
1,000 HP Streetable Turbo Engine
-
![]()
Dropping ETs With Edelbrock’s Progressive Nitrous Oxide System
-
![]()
Bolt-On Coil-On-Plug Tech for Fox-Body & SN95 Mustangs
-
![]()
How It Works: Edelbrock’s HIP Cylinder Head Casting Tech
