Mustang 360
The Ultimate Source for Mustang News and Reviews
0306MM ToHotpt206 Z
Back to Article View Gallery
Back to Article
7 of 50
The block was turned upright and the lifter guide hold-down bar (also called a "spider") was removed along with the lifters. Oster recommends taking special care to reuse the original retaining bolts for the spider. The block is threaded all the way through to the cam bores in this area and using longer bolts will result in the bolt contacting the cam bearings.
More Photo Galleries
-
![]()
Heat Blocking, Noise Cancelling Technology
-
![]()
Vintage Mustang Tech Advice for an Overheated 1965 Mustang Convertible
-
![]()
1,000 HP Streetable Turbo Engine
-
![]()
Dropping ETs With Edelbrock’s Progressive Nitrous Oxide System
-
![]()
Bolt-On Coil-On-Plug Tech for Fox-Body & SN95 Mustangs
-
![]()
How It Works: Edelbrock’s HIP Cylinder Head Casting Tech
