Mustang 360
The Ultimate Source for Mustang News and Reviews
M5lp 1201 S197 Suspension Upgrade Apex Attack 004
Back to Article View Gallery
Back to Article
6 of 15
A car should always be aligned following the installation of lowering springs, and we installed the springs at Steeda’s service facility in Pompano Beach, Florida, rather than trackside at Sebring International Raceway. Without adjustable caster-camber plates, Steve left the caster and camber where they were following the 1-inch drop, at 8.0 and -1.5 degrees respectively. The small increase in negative camber over the factory setting improves cornering ability, but without a significant increase in tire wear. He did, however, adjust the toe-in to 0.13 degrees, which noticeably sharpened the steering response. Track Guys requires its participants to fill out a complete vehicle inspection form before arriving at the track; Steve completed the inspection. This inspection satisfied Track Guys’ requirements and provided peace of mind.
More Photo Galleries
-
![]()
Beefing Up a Cobra IRS Differential
-
![]()
Week to Wicked 2013 Ford Mustang Build Presented by Continental Tire
-
![]()
Stifflers Stiffening Rails Make Jacking a Breeze
-
![]()
Maximizing Front Grip with Maximum Motorsports
-
![]()
Giving a Well-Worn SN95 Rear Axle some Attention from Latemodel Restoration
-
![]()
Week To Wicked 2013 Mustang: Day 5
Mustang 360
Subscribe to a Magazine
© 2018 Mustang 360 Network
Extreme Ventures, LLC dba TEN: A Discovery Communications Company.
All rights reserved.