Chuck Barriner's '67 Ford Mustang Coupe
Chuck Barriner, from Jackson-ville, Florida, can trace his involvement with Mustangs back to 1978, when he joined the Navy and bought his first '65 Mustang coupe. Restoration parts weren't easy to find back then, so he learned to fabricate what he needed. That first Mustang connection created an indelible impression and as a result, he has owned and restored eight Mustangs over the years. Each one was better than the last and he smiles when he says that Mustangs have helped him maintain his sanity throughout 30 years of combined military and police service.
At age 50, Chuck wanted to try his hand one more time, dreaming about creating the ultimate Mustang. In order to do it, however, he had to sell his current ride, a '67 Mustang coupe that had been a consistent winner on the Southeastern show circuit. It was hard to give the car up, since the restoration had taken a long 4 1/2 years and it was only complete for a year and a half. The problem was compounded by the fact that he had received so much help from friends on the project. One of his best, John Faulkenbury, would come over to the house after undergoing radiation treatments to help Chuck install the engine, rebuild the transmission, or add his experience and knowledge to the project.
Chuck eventually sold the Mustang and about the same time, found another '67 coupe on eBay. It was a six-cylinder rust-free California car with no drivetrain, perfect for the new project. What turned out to be a 2 1/2-year restoration began by stripping the car down to the shell, only to discover that his dream car had turned into a nightmare. Gallons of body filler concealed severe damage to the entire left side and front end.
At that point, there was no turning back, so Chuck began purchasing high quality reproduction parts from suppliers like Laurel Mountain Mustangs, Mustangs Unlimited, National Parts Depot, and Mustangs Plus. A fiberglass Shelby-style hood, front valance, side scoops, decklid, and quarter-panel extensions gave the car the styling edge he was looking for. He refined the design with a '67 finned taillight trim panel, Corbin gas cap, new rocker panels, and a careful mix of stripes and emblems.
Once the body was back together, he took all the trim pieces to Atlantic Powder Coating in Atlantic Beach, Florida, to create the unique 'black chrome' look of the car. John's contribution to the Mustang was invaluable. He would often take a trip to his attic-a veritable Mustang parts warehouse-and come down with a GT grille, a complete set of disc and drum brake assemblies, or a Flowmaster exhaust. At one point, Chuck told John he was going to name the Mustang "John's Attic!" "John would always have a smile on his face when he saw the joy those Mustang parts gave me. I can't begin to remember all the parts that he dragged from his attic, but I was grateful," noted Chuck.
Suspension work began by upgrading the six-cylinder Mustang with V-8 parts, incorporating KYB gas shocks and rebuilt 11-inch, four-piston caliper disc brakes up front with 10-inch drum versions in the rear. Chuck and John installed a professionally rebuilt 351 Cleveland purchased from Titan Engines in Ocala, Florida. Bored 0.030-inches over, the engine was equipped with a 600-cfm Holley carburetor on an Edelbrock Performer manifold, Procomp ignition, and stock Ford exhaust manifolds flowing into Flowmaster mufflers. John rebuilt the C6 automatic transmission, adding a TCI torque converter and TransGo shift kit. Florida Power Train was responsible for rejuvenating the 9-inch Ford Traction-Lok differential. Power gets to the asphalt thanks to the 18x8.5 triple chromed Incubus Shylock rims and Nexen 3000 rubber, P235/40ZR18 up front, and P245/40ZR18 in the rear.